Embroidery Magic 2 software is very easy to use to make lettering, it is also easy to learn to use the digitizing part of the program but to digitize a good design takes learning, skill and practice. An example of what I am saying is that - for a artist to paint a picture, all it takes is some canvas, paint and brushes (these supplies and tools are easy for anyone to use but it takes learning, practice and artistic skill to paint a beautiful picture. The EM 2 program is easy to use but to digitize a good design takes learning, practice and skill. By the way, one of the best ways to actually learn how to digitize a good design (not the same as how to use the software program) is to watch a good design stitch out and see/learn why the digitizer does this and that as the design stitches - we have lots of good designs (learning tools) as you may have noticed or our web site. Embroidery Magic 2 is a "free standing digitizing software program - ie - it works on it's own on your computer" and saves designs on/to your computer in the dst format - dst is a standard format that converts well to almost any format or can be used directly by most software that sends a design to an embroidery machine via a memory card, floppy disk or direct connect. Most any software or boxes that send a design to a card and can use the dst format will work. If the software that sends the designs to the machine can use dst then conversion is not required, otherwise the design or lettering must be converted to a right format for the machine so it can be sent to a card or machine. There is a very good conversion program available for free if you need it. Just email us for the link after purchasing the EM 2 software. |
Index Page
